Debian etc network interfaces manual






















In /etc/network/interfaces to section iface add parameter: vlan-raw-device eth0. The interface name should be the raw interface name (the same as specified by vlan-raw-device), then a dot, then the VLAN ID, for example eth It can instead be . The man page says what comes after the interface name is the address family that the interface uses. "inet" is the name for IPv4, inet6 for www.doorway.rus: 1. For advice on configuring this package read the Network Configuration chapter of the Debian Reference manual, available at www.doorway.ru or in the debian-reference-en package. Examples of how to set up interfaces can be found in /usr/share/doc/ifupdown/examples/www.doorway.ru


A. /etc/network/interfaces file contains network interface configuration information for the both Ubuntu and Debian Linux. This is where you configure how your system is connected to the network. Defining physical interfaces such as eth0. The file /etc/network/interfaces available in Debian and its derived distributions allows to define static and dynamic IP addresses for the interfaces, setup routing information and default gateways, masquerading network bonding and more. The default interfaces file looks like the following. The first option is to add IP address configuration directly into /etc/network/interfaces file. Append the following line to your existing /etc/network/interfaces: address netmask gateway The resulting content /etc/network/interfaces file should look like the one below. Update your IP address, netmask and gateway as necessary.


Once the network is configured, you can use the Debian The corresponding configuration in /etc/network/interfaces might look like this. Iface: Command that specifies an X interface (EthX, WlanX, EnpXsX, WlpXsX) and the type of configuration (Inet) that will be applied to you. dhcp: refers to a. Ethernet Interfaces. One of the most common interface files is /etc/sysconfig/network-scripts/ifcfg-eth0, which controls.

0コメント

  • 1000 / 1000