789-44 connecting block manual

The Model provides a quick low cost means of connecting. Xantech IR receivers and keypads to four single or four dual. emitters, with a power supply, in an infrared repeater system. It. can also provide emitter expansion for various Xantech devices, such as the , , , , , etc.. The STATUS. 1-zone Connecting Block (with Power Supply) Product description The provides a quick low cost means of connecting Xantech IR receivers and keypads to four single or four dual emitters, with a power supply, in an infrared repeater www.doorway.rus: 9. Modules Connecting Blocks INSTALLATION INSTRUCTIONS 12VDC +12 IR VDC GND STATUS IR IN EMITTERS CONNECTING BLOCK ® RCVR Fig. 1 Model Connecting Block The Model provides a quick low cost means of connecting Xantech IR receivers and keypads to four single or four dual emitters, with a power supply, in an infrared .

Xantech PSRP. One Zone Four Source Connecting Block Including Power Supply. with included ERGPS Power Supply. Xantech PSRP Features at a Glance. Connects four emitter ports and power supply to all Xantech infrared receivers and keypads. Four parallel emitter ports with Ohm resistors drive four single or four dual emitters. Xantech Connecting Block. CABLE CONNECTIONS ML95s may also be used where the 7-foot cable is not long enough. Simply cut off the mini plug, strip the leads and splice them to a 3-conductor extension cable with a terminal block or other means. Then connect the extension cable to the 3- or 4-terminal block on the connecting block. ML Series. the wire run to the connecting block. A 3-terminal block can be purchased separately to connect the IR receiver to the connecting block with a 3-conductor inter-room cable in between. DL Series IR Receiver Red (or Vwhite) Stripe To V AC (unswitched) ERGPS Connecting Block REMOTE MROOM AIN R O Hand Hel d Remote 3-Terminal Block.

Quick-Connect mm Stereo Mini Plug on 7ft. (cm) cable for direct plug-in to Xantech Connecting Blocks. • Works in normal 3-wire mode (12VDC, IR. The provides a quick low cost means of connecting Xantech IR receivers and keypads to four single or four dual emitters, with a power supply, in an. ML85K to the manual 5bf1-eedadb-b12bff1bc · 1. Connect the IR receiver to the “IR RCVR” port on the connecting. block. · 2. Connect.